Preparing for Service 45
Preparing for Service
These topics describe how to prepare the server for servicing.
Step Description Link
1 Review safety and handling information. “Safety Information” on page 45
2 Gather the tools needed for service. “Tools Needed for Service” on page 47
3 Consider filler panel options. “Filler Panels” on page 48
4 Find the server serial number. “Find the Server Serial Number” on page 49
5 Identify the server to be serviced. “Locate the Server” on page 50
6 Locate the component service information. “Component Service Task Reference” on page 20
7 For cold-service operations, shut down the OS. “Removing Power From the Server” on page 51
8 Gain access to service components. “Chassis Subassembly Components” on page 17
Safety Information
For your protection, observe the following safety precautions when setting up your equipment:
■
Follow all cautions and instructions marked on the equipment and described in the
documentation shipped with your server.
■
Follow all cautions and instructions marked on the equipment and described in the SPARC
T5-4 Server Safety and Compliance Guide.
■
Ensure that the voltage and frequency of your power source match the voltage and
frequency inscribed on the equipment's electrical rating label.
■
Follow the ESD safety practices as described in this section.
This topic includes the following sections:
■
“Safety Symbols ” on page 46
■
“ESD Precautions” on page 46
■
“Antistatic Wrist Strap” on page 47
■
“Antistatic Mat” on page 47
To Next Page
Loading...
Need help?
General