Oracle SPARC T5-4 User Manual

Verify the PCIe Card
170 SPARC T5-4 Server Service Manual • July 2016
■
Use the Oracle Solaris hotplug command.
For example:
# hotplug enable PCIE7
■
Use the Oracle Solaris cfgadm command:
# cfgadm -c connect Ap-id
where Ap_id is the ID of the card that you want to connect.
6.
Verify the PCIe card's installation.
See “Verify the PCIe Card” on page 170.
Related Information
■
“Determine Which PCIe Card Is Faulty” on page 157
■
“Remove a PCIe Card Carrier” on page 158
■
“Install a PCIe Carrier Extension” on page 167
■
“Verify the PCIe Card” on page 170
Verify the PCIe Card
1.
Verify that the PCIe card carrier Fault LED is not illuminated.
2.
Verify that the System Service Required LEDs on the front panel and rear I/O
module are not illuminated.
See “Interpreting LEDs” on page 28.
3.
Verify that the System PCIe Fault LED on the front panel is not illuminated.
See “Front Panel Controls and LEDs” on page 29.
4.
Perform one of the following tasks based on your verification results:
■
If any of the LEDs are illuminated, see “Diagnostics Process” on page 23.
■
If none of the LEDs are illuminated, go to Step 6.
5.
Verify that the green Power LED is lit on the PCIe card carrier that you installed.
6.
At the Oracle Solaris prompt, ensure that the PCIe card is connected and online:

Oracle SPARC T5-4 Specifications

General

Brand	Oracle
Model	SPARC T5-4
Category	Server
Language	English