Install a Hard Drive
Servicing Hard Drives 93
Related Information
■
“Determine Which Hard Drive Is Faulty” on page 90
■
“Install a Hard Drive” on page 93
■
“Verify the Hard Drive” on page 94
Install a Hard Drive
Hard drives are hot-service components that can be replaced by customers. For the location of
the hard drives, see “Hard Drive Locations” on page 87.
Caution - This procedure requires that you handle components that are sensitive to electrostatic
discharge. This discharge can cause failure of server components.
1.
Align the replacement drive to the drive slot, and slide the drive in until it is
seated.
Drives are physically addressed according to the slot in which they are installed. If you are
replacing a drive, install the replacement drive in the same slot as the drive that was removed.
See “Hard Drive Locations” on page 87 for drive slot information.
2.
Close the latch to lock the drive in place.
3.
Verify the installation.
See “Verify the Hard Drive” on page 94.
Related Information
■
“Determine Which Hard Drive Is Faulty” on page 90
To Next Page
Loading...
Need help?
General