Oracle SPARC T5-4 User Manual

Verify the System Configuration PROM
124 SPARC T5-4 Server Service Manual • July 2016
.
SPARC T5-4, No Keyboard
.
OpenBoot X.XX, 16256 MB memory available, Serial
#87304604.Ethernet address *:**:**:**:**:**, Host ID: ********
.
.
.
2.
For additional verification, run specific commands to display data stored in the
system configuration PROM.
■
Use the Oracle ILOM show command to display the MAC address:
-> show /HOST macaddress
/HOST
Properties:
macaddress = **:**:**:**:**:**
■
Use Oracle Solaris OS commands to display the hostid and Ethernet address:
# hostid
8534299c

# ifconfig -a
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232
index 1
inet 127.0.0.1 netmask ff000000
igb0: flags=201004843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 2
inet 10.6.88.150 netmask fffffe00 broadcast 10.6.89.255
ether *:**:**:**:**:**

Oracle SPARC T5-4 Specifications

General

Brand	Oracle
Model	SPARC T5-4
Category	Server
Language	English

Summary

Preparing for Service

Safety Information

Outlines essential safety precautions for equipment servicing.

ESD Precautions

Details precautions for handling electrostatic discharge-sensitive components.

Servicing Processor Modules

Server Upgrade Process

Details the process for upgrading the server with a second processor module.

Determine Which Processor Module Is Faulty

Guides on identifying a faulty processor module using LEDs.

Remove a Processor Module or Processor Filler Module

Step-by-step instructions for removing processor modules or filler modules.

Install a Processor Module or Processor Filler Module

Step-by-step instructions for installing processor modules or filler modules.

Servicing DIMMs

Determine Which DIMM is Faulty (PSH)

Using PSH to identify faulty DIMMs via fmadm faulty command.

Servicing Hard Drives

Determine Which Hard Drive Is Faulty

Guides on identifying a faulty hard drive using its LEDs.

Remove a Hard Drive

Step-by-step instructions for removing a hard drive from the server.

Install a Hard Drive

Step-by-step instructions for installing a hard drive into the server.

Servicing the Main Module

Determine if the Main Module Is Faulty

Guides on identifying a faulty main module using its Service Required LED.

Remove the Main Module

Step-by-step instructions for removing the main module from the server.

Install the Main Module

Step-by-step instructions for installing the main module into the server.

Servicing Power Supplies

Determine Which Power Supply Is Faulty

Remove a Power Supply

Install a Power Supply

Servicing Fan Modules

Determine Which Fan Module Is Faulty

Remove a Fan Module

Install a Fan Module

Servicing PCIe Cards

Determine Which PCIe Card Is Faulty

Remove a PCIe Card Carrier

Install a PCIe Card

Servicing the Rear I/O Module

Determine if the Rear I/O Module Is Faulty

Remove the Rear I/O Module

Install the Rear I/O Module

Servicing the Rear Chassis Subassembly

Remove the Rear Chassis Subassembly

Install the Rear Chassis Subassembly