Copyright© Orphée SA. All Rights Reserved.
Guidance and manufacturer’s declaration – electromagnetic immunity.
The MYTHIC 22 is intended for use in the electromagnetic environment specified below. The customer or
the user of the MYTHIC 22 should assure that it is used in such an environment.
Electromagnetic environment - guidance
Portable and mobile RF communications equipment should
be used no closer to any part of the MYTHIC 22,
including cables, than the recommended separation
distance calculated from the equation applicable to the
frequency of the transmitter.
Recommended separation distance
Conducted RF
IEC 61000-4-6
IEC 61000-4-3
80Mhz to 2,5Ghz
d
= 1,2√
P
80MHz to 800MHz
d
= 2,3√
P
800MHz to 2,5GHz
Where P is the maximum output power rating of the
transmitter in watts (W) according to the transmitter
manufacturer and d is the recommended separation
Field strengths from fixed RF transmitters, as
determined by an electromagnetic site survey,
a
should be
less than the compliance level in each frequency range.
Interference may occur in the vicinity of equipment
marked with the following symbol:
NOTE 1 At 80Mhz and 800MHz, the higher frequency range applies.
NOTE 2 Theses guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from
structures, objects and people.
a
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios,
amateur radio, AM an FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess the
electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey should considered. If the measured field
strength in the location in which the MYTHIC 22 is used exceeds the applicable RF compliance level above, the MYTHIC 22 should be
observed to verify normal operation. If abnormal performance is observed, additional measures may be necessary, such as re-orienting
or relocating the MYTHIC 22.
b
Over the frequency range 150KHz to 80MHz, field strengths should be less than 3V/m.
The symbol on the product indicates that this product may not be treated as household waste. Instead it shall be handed
over the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of
correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be
caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please
contact your local city office or your distributor of this product.
To Next Page
Loading...