Panasonic DLP PT-RZ34K

Chapter 4 Settings — [PICTURE] menu
112 - ENGLISH
Terminal System format
<HDMI IN> terminal,
<DIGITAL LINK> terminal,
<HDMI IN 1> terminal, <HDMI
IN 2> terminal
480/60p or 576/50p signal Select [AUTO], [RGB], or [YC
B
C
R
].
Signals other than above Select [AUTO], [RGB], or [YP
B
P
R
].
<DVI-D IN> terminal, <DVI-D
IN 1> terminal, <DVI-D IN 2>
terminal
480/60p or 576/50p signal Select [RGB] or [YC
B
C
R
].
Signals other than above Select [RGB] or [YP
B
P
R
].
<DisplayPort IN 1> terminal,
<DisplayPort IN 2> terminal
Select [AUTO], [RGB], or [YP
B
P
R
].
4) Press the <ENTER> button.
Note
f For details of the types of video signals that can be used with the projector, refer to “List of compatible signals” (x page 309).
f This may not function properly for some connected external devices.
f The selection item for the input signal to the <HDMI IN 1> terminal and the <HDMI IN 2> terminal can be selected when the optional
Interface Board equipped with the HDMI input is installed in <SLOT>.
f The selection item for the input signal to the <DVI-D IN 1> terminal and the <DVI-D IN 2> terminal can be selected when the optional
Interface Board equipped with the DVI-D input is installed in <SLOT>.
f The selection item for the input signal to the <DisplayPort IN 1> terminal and the <DisplayPort IN 2> terminal can be selected when the
optional Interface Board equipped with the DisplayPort input is installed in <SLOT>.
f For the SDI input and the SDI OPT input, the signal format can be set in detail in the [DISPLAY OPTION] menu → [SDI IN]/[SLOT IN].
sRGB-compliant video
sRGB is an international standard (IEC61966-2-1) for color reproduction dened by IEC (International
Electrotechnical Commission).
Set according to the following steps to reproduce more faithful, sRGB compliant colors.
1) Set [COLOR MATCHING] to [OFF].
f Refer to [COLOR MATCHING] (x page 133).
2) Display the [PICTURE] menu.
f Refer to “[PICTURE] menu” (x page 104).
3) Press as to select [PICTURE MODE].
4) Press qw to set [NATURAL].
5) Press as to select [COLOR].
6) Press the <DEFAULT> button on the remote control to set the factory default setting.
7) Follow Steps 5) to 6) to set [TINT], [COLOR TEMPERATURE], [GAMMA], and [SYSTEM DAYLIGHT
VIEW] to the factory default settings.
Note
f sRGB is available for RGB signal input only.