Panasonic DLP PT-RZ34K

Chapter 3 Basic Operations — Switching on/off the projector
76 - ENGLISH
When the administrator account setting screen is displayed
When the projector is switched on for the rst time after purchase, or when the [PROJECTOR SETUP] menu →
[INITIALIZE] → [FACTORY RESET] is executed, the focus adjustment screen, the [INITIAL SETTING] screen,
and then the [ADMINISTRATOR ACCOUNT] screen is displayed in order after the projection starts. If the
[PROJECTOR SETUP] menu → [INITIALIZE] → [NETWORK/E-MAIL ONLY] is executed, the [ADMINISTRATOR
ACCOUNT] screen is displayed after the projection starts.
When using the network function of the projector, set a user name and password of the administrator account. It
can be set later in the [NETWORK] menu → [ADMINISTRATOR ACCOUNT].
[PASSWORD POLICY]
Display a policy about the password of the administrator account.
1) Press as to select [PASSWORD POLICY], and press the <ENTER> button.
f The [PASSWORD POLICY] screen is displayed.
f Press the <MENU> button to return to the [ADMINISTRATOR ACCOUNT] screen.
PASSWORD POLICY
Reusing passwords is not recommended.
Password cannot be blank.
A password consisting of at least eight
half-width characters and contaning
characters of at least three of the
following four types is recommended.
Uppercase letters
Lowercase letters
Digits
Symbols (~!@#$%^&*()_+\|}{][<>.,/?`)
RETURN
MENU
Setting the administrator account
Set the user name and password of the account with administrator rights.
1) Press as to select [USER NAME], and press the <ENTER> button.
f The [USER NAME] screen is displayed.
f The factory default setting of the user name for the administrator account is set to “dispadmin”.
2) Press asqw to select the text, and press the <ENTER> button to enter the text.
f Up to 16 characters can be entered.
3) After the user name is entered, press asqw to select [OK], and press the <ENTER> button.
f The [ADMINISTRATOR ACCOUNT] screen is displayed.
4) Press as to select [PASSWORD], and press the <ENTER> button.
f The [PASSWORD] screen is displayed.
5) Press asqw to select the text, and press the <ENTER> button to enter the text.
f Up to 16 characters can be entered.
f A password cannot be blank.
6) After the password is entered, press asqw to select [OK], and press the <ENTER> button.
f The [ADMINISTRATOR ACCOUNT] screen is displayed.
7) Press as to select [PASSWORD CONFIRM], and press the <ENTER> button.
f The [PASSWORD] screen is displayed.
8) Enter the password entered in Step 5).
9) After the password is entered, press asqw to select [OK], and press the <ENTER> button.
f The [ADMINISTRATOR ACCOUNT] screen is displayed.