Panasonic DLP PT-RZ34K

Chapter 4 Settings — [ADVANCED MENU] menu
ENGLISH - 121
[ADVANCED MENU] menu
On the menu screen, select [ADVANCED MENU] from the main menu, and select an item from the sub-
menu.
Refer to “Navigating through the menu” (x page 98) for the operation of the menu screen.
[DIGITAL CINEMA REALITY]
The picture quality is enhanced by raising the vertical resolution higher performing the cinema processing when
interlace signal for moving image is input.
1) Press as to select [DIGITAL CINEMA REALITY].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO] Automatically detects the input signal and performs cinema processing.
[OFF] Does not perform cinema processing.
[30p FIXED]
When 60 Hz vertical scanning
frequency signals are input
Performs forced cinema processing (2:2 pulldown).
[25p FIXED]
When 50 Hz vertical scanning
frequency signals are input
Note
f In [DIGITAL CINEMA REALITY], the picture quality will degrade when a signal other than the 2:2 pulldown is set as [25p FIXED] or [30p
FIXED]. (Vertical resolution will degrade.)
f [DIGITAL CINEMA REALITY] is xed to [OFF] in the following cases.
g When [FRAME RESPONSE] is set to [FAST]
f The [DIGITAL CINEMA REALITY] setting is disabled and xed to [OFF] when [DIGITAL CINEMA REALITY] is set to anything other than
[OFF] and the following setting or operation is performed.
g Set [FRAME RESPONSE] to [FAST].
[BLANKING]
Adjust the blanking width if there is a noise at the edge of the screen or the image is slightly running out from the
screen.
1) Press as to select [BLANKING].
2) Press the <ENTER> button.
f The [BLANKING] adjustment screen is displayed.
3) Press as to select [UPPER], [LOWER], [LEFT], or [RIGHT].
f When [CUSTOM MASKING] is selected and set to anything other than [OFF] ([PC-1], [PC-2], [PC-3]),
the blanking width can be adjusted to arbitrary shape using a computer and the masking function of the
“Geometric & Setup Management Software”. Up to three adjustment data can be saved.
4) Press qw to adjust the blanking width.
Blanking correction Item Operation Adjustment Range of adjustment
Top of the screen [UPPER]
Press q.
The blanking zone
moves upward.
Top and bottom 0 - 2398
Press w.
The blanking zone
moves downward.
Bottom of the
screen
[LOWER]
Press w.
The blanking zone
moves upward.
Press q.
The blanking zone
moves downward.