Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 205
5) Press the <ENTER> button.
f The [USER SETTINGS] screen is displayed.
6) Press as to select an item.
[OPERATION SETTING]
The [PROJECTOR SETUP] menu → [OPERATION SETTING] → [OPERATING MODE] and [MAX
LIGHT OUTPUT LEVEL] are initialized.
[LIGHT OUTPUT] is not initialized. The [LIGHT OUTPUT] setting is maintained.
[REGISTERED SIGNAL] All the signals registered in [SIGNAL LIST] are initialized.
[NETWORK/E-MAIL]
All the setting items under the [NETWORK] menu and all the setting items under the operation page
in the [Detailed set up] page and the Crestron Connected of the web control screen are initialized.
f The items of [Time Zone], [Date], and [Time] in the web control screen are not initialized.
f The information such as the self-signed certicate already created in the [Https set up] page of the
web control screen or the server certicate already installed is not initialized.
[LOGO IMAGE] Image registered in [USER LOGO] is initialized.
[UNIFORMITY]
The [DISPLAY OPTION] menu → [UNIFORMITY] is initialized.
[CONVERGENCE]
The [POSITION] menu → [CONVERGENCE] is initialized.
[OTHER USER SETTING] The user data other than mentioned above are initialized.
7) Press qw to switch the setting.
f The items will switch each time you press the button.
[KEEP]
Does not return to the factory default settings and maintains the current settings when initialization is
executed by [USER SETTINGS].
[INITIALIZE] Returns to the factory default settings when initialization is executed by [USER SETTINGS].
f Repeat Steps 6) to 7) until the desired initialization items are set.
8) Press as to select [INITIALIZE].
9) Press the <ENTER> button.
f The conrmation screen is displayed.
10) Press qw to select [OK], and press the <ENTER> button.
Note
f To return the setting in the [PROJECTOR SETUP] menu → [LIGHT OUTPUT] to the factory default setting, initialize it by selecting [OTHER
USER SETTING].
f To return the setting of [Time Zone] in the [Adjust clock] page of the web control screen and the setting of the [PROJECTOR SETUP] menu
→ [DATE AND TIME] → [TIME ZONE] to the factory default settings, initialize them by one of the following methods.
g Initializing by selecting the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY RESET]
g Initializing by setting the [PROJECTOR SETUP] menu → [INITIALIZE] → [USER SETTINGS] → [OTHER USER SETTING] to
[INITIALIZE]
[FIRMWARE UPDATE]
Rewriting of the rmware is possible by using a USB memory.
For details of operation, refer to “Updating the rmware using the USB memory” (x page 280).
[SERVICE PASSWORD]
This function is used by a service person.
To Next Page
Loading...
