Panasonic DLP PT-RZ34K

Chapter 7 Appendix — Specications
ENGLISH - 305
Specications
The specications of the projector are as follows.
Display system 3-chip DLP projection system
Display device
Size of effective display
area
24.4 mm (0.96") x 3 (aspect ratio 16:10)
Number of pixels 2 304 000 pixels (1 920 x 1 200 dots)
Projection lens
Supplied projection
lens
Optional
Zoom Powered
Focus Powered
Lens shift Powered (Horizontal/Vertical)
Changeable lens Yes
Light source Laser diode
Screen size
1.78 m (70") to 25.40 m (1 000")
1.78 m (70") to 15.24 m (600") with ET-D3LET80, ET-D75LE8
5.08 m (200") to 15.24 m (600") with ET-D3LEW200, ET-D3LEU100
3.05 m (120") to 15.24 m (600") with ET-D75LE95
Light output
*1*2
30 500 lm when [OPERATING MODE] is set to [NORMAL]
24 000 lm when [OPERATING MODE] is set to [ECO]
20 000 lm when [OPERATING MODE] is set to [QUIET]
Contrast ratio
*1
20 000:1 when [DYNAMIC CONTRAST] is set to [3]
Center to corner zone ratio
*1
90 %
Displayable
scanning
frequency
Horizontal 27 kHz to 135 kHz
Vertical 24 Hz to 120 Hz
Input
compatibility
HDMI signal input
Moving image signal resolution:
480/60p, 576/50p to 4 096 x 2 160/60p
Still image signal resolution:
640 x 480 to 3 840 x 2 400 (non-interlace)
Dot clock frequency:
25 MHz to 594 MHz
DVI-D signal input
Moving image signal resolution:
480/60p, 576/50p to 2 048 x 1 080/60p
Still image signal resolution:
640 x 480 to 1 920 x 1 200 (non-interlace)
Dot clock frequency:
25 MHz to 162 MHz
DIGITAL LINK signal
input
Moving image signal resolution:
480/60p, 576/50p to 4 096 x 2 160/60p
Still image signal resolution:
640 x 480 to 3 840 x 2 400 (non-interlace)
Dot clock frequency:
25 MHz to 297 MHz
SDI signal input HD-SDI signal, 3G-SDI signal, 6G-SDI signal, 12G-SDI signal
DisplayPort signal
input
*3
Moving image signal resolution:
720/50p to 4 096 x 2 160/60p
Still image signal resolution:
640 x 480 to 3 840 x 2 400 (non-interlace)
Dot clock frequency:
25 MHz to 594 MHz
SDI OPT signal input
*4
HD-SDI signal, 3G-SDI signal, 6G-SDI signal, 12G-SDI signal
*1 Measurement, measuring conditions, and method of notation all comply with ISO/IEC 21118:2020 international standards.
*2 When a projection lens other than ET-D75LE95 is used with the power supply voltage of AC 200 V.
*3 This is supported when the optional Interface Board for DisplayPort 2 input (Model No.: ET-MDNDP10) is installed in the slot.
*4 This is supported when the optional Interface Board for 12G-SDI Optical (Model No.: ET-MDNFB10) is installed in the slot.