Panasonic DLP PT-RZ34K

Chapter 5 Operations — Updating the rmware
280 - ENGLISH
Note
f In following cases, turn the power of the projector off and on and perform the update from the beginning.
g When the update does not complete after 60 minutes or more have elapsed
g When the power of the projector or the computer has turned off due to power outage, etc., during the update
Updating the rmware using the USB memory
Supported device
f Commercially available USB memory is supported.
The USB memory with a security function is not supported.
f Only the cards formatted in FAT16 or FAT32 can be used.
f Only the single partition structure is supported.
Acquiring the rmware
Download the rmware data for this projector (compressed le in zip format) from the Panasonic website (https://
panasonic.net/cns/projector/pass/).
f File name (example): RZ34K_USER_101_102.zip
(Firmware data for PT-RZ34K with main version 1.01/network version 1.02)
Preparing the USB memory
Prepare the USB memory to be used for update.
1) Extract the compressed file downloaded from the website.
f The rmware data (le in rom format) is generated.
File name (example): RZ34K_USER_101_102.rom
2) Save the firmware data generated by extracting into the USB memory.
f Save in the root directory of the formatted USB memory.
Note
f Delete everything other than the rmware data to be used for update from the USB memory.
f For the handling of the USB memory, refer to “Using the USB memory” (x page 92).
Operating the OSD to update the rmware
1) Insert the USB memory with the firmware data saved into the <USB> terminal of the projector.
2) Turn on the power of the projector.
3) Press the <MENU> button on the remote control or control panel.
f The [MAIN MENU] screen is displayed.
4) Press as to select [PROJECTOR SETUP].
5) Press the <ENTER> button.
f The [PROJECTOR SETUP] screen is displayed.
6) Press as to select [FIRMWARE UPDATE].
7) Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
8) Enter a security password and press the <ENTER> button.
f The [FIRMWARE UPDATE] screen is displayed.
9) Press qw to select [OK], and press the <ENTER> button.
f Update is started.
f The projector goes into the standby mode once the update is started, and the light source indicator
<LIGHT> and the temperature indicator <TEMP> blink in red alternately.