Panasonic DLP PT-RZ34K

Chapter 4 Settings — [NETWORK] menu
216 - ENGLISH
3) Press as to select [EXTRON XTP].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Select this item when connecting the optional DIGITAL LINK output supported device (Model No.:
ET-YFB100G, ET-YFB200G) to the <DIGITAL LINK> terminal.
[ON]
Select this item when connecting the “XTP transmitter” of Extron Electronics to the <DIGITAL LINK>
terminal.
Note
f For details of the “XTP transmitter”, visit the website of Extron Electronics.
URL http://www.extron.com/
[WIRED LAN]
Perform the connection setting to use the wired LAN.
1) Press as to select [WIRED LAN].
2) Press the <ENTER> button.
f The [WIRED LAN] screen is displayed.
3) Press as to select an item, and change the settings according to the operation instructions of the
menu.
[DHCP]
[ON]
If a DHCP server exists in the network where the projector is to be
connected, obtains the IP address automatically.
[OFF]
If a DHCP server does not exist in the network where the projector
is to be connected, set [IP ADDRESS], [SUBNET MASK], and
[DEFAULT GATEWAY].
[IP ADDRESS] Enter the IP address when a DHCP server is not used.
[SUBNET MASK] Enter the subnet mask when a DHCP server is not used.
[DEFAULT GATEWAY] Enter the default gateway address when a DHCP server is not used.
4) Press as to select [STORE], and press the <ENTER> button.
f The conrmation screen is displayed.
5) Press qw to select [OK], and press the <ENTER> button.
Note
f When using a DHCP server, conrm that the DHCP server is running.
f Consult your network administrator regarding the IP address, subnet mask, and default gateway.
f When [Art-Net SETUP] is set to [ON(2.X.X.X)] or [ON(10.X.X.X)], [WIRED LAN] cannot be selected.
f The network setting is common for the <LAN> terminal and the <DIGITAL LINK> terminal.
f Wired LAN and wireless LAN cannot be used in the same segment.
[WIRELESS LAN]
Set the connection method of wireless LAN and its details.
f To use the wireless LAN function with the projector, it is necessary to attach the optional Wireless Module
(Model No.: AJ-WM50 Series) to the <USB> terminal.
1) Press as to select [WIRELESS LAN].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[ENABLE]
Select this item when the wireless LAN is to be used.
A device such as a smartphone can be directly connected to the projector even if a wireless LAN
access point is not set up separately because the projector is used as a simplied access point.
For setting procedure of the connection key, refer to “Setting the connection key” (x page 217).
[DISABLE] Select this item when the wireless LAN is not to be used.
Note
f [WIRELESS LAN] cannot be set if the optional Wireless Module (Model No.: AJ-WM50 Series) is not attached to the <USB> terminal.