Panasonic DLP PT-RZ34K

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 203
Setting the brightness of the information monitor
Set the brightness of the information monitor.
1) Press as to select [INFO MONITOR SETTING].
2) Press the <ENTER> button.
f The [INFO MONITOR SETTING] screen is displayed.
3) Press as to select [BRIGHTNESS].
4) Press qw to adjust the level.
Operation Adjustment Range of adjustment
Press w.
The information monitor becomes bright.
30 % - 100 %
(Factory default setting: 100 %)
Press q.
The information monitor becomes dark.
Note
f [BRIGHTNESS] is adjusted in increments of 10.
f This can also be set with operation in the information monitor. For details, refer to “Using the information monitor function” (x page 261).
[DATA CLONING]
Perform the operation of the data cloning function. Data such as the settings and adjustment values of the
projector can be copied to multiple projectors via LAN or using the USB memory.
For details of operation, refer to “Using the data cloning function” (x page 271).
[SAVE ALL USER DATA]
Save the various setting values as a backup in the built-in memory of the projector.
1) Press as to select [SAVE ALL USER DATA].
2) Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3) Enter a security password and press the <ENTER> button.
f The conrmation screen is displayed.
4) Press qw to select [OK], and press the <ENTER> button.
f [PROGRESS] is displayed while saving data.
Note
f The data saved by executing [SAVE ALL USER DATA] does not include the data set with “Geometric & Setup Management Software”.
f The data saved by executing [SAVE ALL USER DATA] is not deleted even if the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY
RESET] is executed.
[LOAD ALL USER DATA]
Load the various setting values saved as a backup in the built-in memory of the projector.
1) Press as to select [LOAD ALL USER DATA].
2) Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3) Enter a security password and press the <ENTER> button.
f The conrmation screen is displayed.
4) Press qw to select [OK], and press the <ENTER> button.
Note
f The projector enters the standby mode to reect the setting values when [LOAD ALL USER DATA] is executed.
f The data loaded from [LOAD ALL USER DATA] does not include the data set with “Geometric & Setup Management Software”.