Chapter 4āSettings ā [POSITION] menu
118 - ENGLISH
7) Press asqw to adjust.
Adjusting distortion with [FREE GRID]
1) Press as to select [GEOMETRY].
2) Press qw to select an item other than [OFF].
3) Press the <ENTER> button.
f The screen for the selected item is displayed.
4) Press as to select [FREE GRID].
5) Press qw to select an item.
f The items will switch each time you press the button.
[OFF] Disables the adjustment to be performed with [FREE GRID].
[ON] Enables the adjustment to be performed with [FREE GRID].
f Proceed to Step 6) when [ON] is selected.
6) Press the <ENTER> button.
f The [FREE GRID] screen is displayed.
7) Press as to select [GRID RESOLUTION].
8) Press qw to switch the item.
f The items will switch each time you press the button.
[2x2]
Performs the adjustment using the pattern of the outer border (there are two lines each vertically and
horizontally as a grid line).
[3x3]
Performs the adjustment using the grid pattern divided into two in the horizontal direction and also in
the vertical direction.
[5x5]
Performs the adjustment using the grid pattern divided into four in the horizontal direction and also in
the vertical direction.
(Factory default setting)
[9x9]
Performs the adjustment using the grid pattern divided into eight in the horizontal direction and also in
the vertical direction.
[17x17]
Performs the adjustment using the grid pattern divided into 16 in the horizontal direction and also in
the vertical direction.
9) Press as to select [CONTROL POINTS].
10) Press qw to switch the item.
f The items will switch each time you press the button.
[POINT] Select this item when adjusting by selecting one intersection from the intersections on the grid lines.
[HORIZONTAL LINE]
Select this item when selecting all the intersections on one horizontal grid line, and adjusting them
simultaneously.
[VERTICAL LINE]
Select this item when selecting all the intersections on one vertical grid line, and adjusting them
simultaneously.
11) Press as to select [GRID WIDTH].
12) Press qw to switch the item.
f The items will switch each time you press the button.
[1] - [10]
Select the width of the grid line. It can be set between 1 line to 10 lines.
(Factory default setting: [3])
13) Press as to select [GRID COLOR].
14) Press qw to switch the item.
f The items will switch each time you press the button.
To Next Page
Loading...
