Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 169
[LENS INFORMATION SETTING]
Conrming the projection lens information
1) Press as to select [LENS].
2) Press the <ENTER> button.
f The [LENS] screen is displayed.
3) Press as to select [LENS INFORMATION SETTING].
4) Press the <ENTER> button.
f The [LENS INFORMATION SETTING] screen is displayed.
[LENS ID] Displays the set ID.
[LENS NAME] Displays the set name.
[LENS TYPE] Displays the set projection lens type.
[LENS ZOOM TYPE] Displays the drive method of the zoom motor.
Note
f [LENS INFORMATION SETTING] is not displayed when a projection lens without built-in EEPROM is attached.
Setting ID to the projection lens
Write the identication information unique to the projection lens into the EEPROM built in the projection lens. Set
ID if required.
1) Press as to select [LENS].
2) Press the <ENTER> button.
f The [LENS] screen is displayed.
3) Press as to select [LENS INFORMATION SETTING].
4) Press the <ENTER> button.
f The [LENS INFORMATION SETTING] screen is displayed.
5) Press as to select [LENS ID].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[ALL] Select this item when the ID number is not to be specied.
[1] - [255] Select this item when the ID number is to be set.
Note
f [LENS INFORMATION SETTING] is not displayed when a projection lens without built-in EEPROM is attached.
f If the standard DC motor unit installed in the Zoom Lens (Model No.: ET-D75LE6, ET-D75LE8, ET-D75LE10, ET-D75LE20, ET-D75LE30,
ET-D75LE40, etc.) is replaced with the stepping motor unit using the Stepping Motor Kit (Model No.: ET-D75MKS10), the [LENS ID]
information is written into the EEPROM built in the stepping motor unit every time the [LENS ID] item is switched.
f [LENS ID] will not return to the factory default setting even when initialized by any of the following methods.
g When initialized by selecting the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY RESET]
g When initialized by setting the [PROJECTOR SETUP] menu → [INITIALIZE] → [USER SETTINGS] → [OTHER USER SETTING] to
[INITIALIZE]
Setting name to the projection lens
A name for identifying individual projection lens can be written into the EEPROM built in the projection lens. Set
the name if required.
1) Press as to select [LENS].
2) Press the <ENTER> button.
f The [LENS] screen is displayed.
To Next Page
Loading...
