Panasonic DLP PT-RZ34K

Chapter 7 Appendix — Technical information
ENGLISH - 299
f Example: Transmission of power supply status acquisition command (hash value is calculated from the user
name and password of the administrator account, and acquired random number)
“dbdd2dabd3d4d68c5dd970ec0c29fa6400QPW” (CR)
r Received data
Header Data section
Termination
symbol
Command
example
‘0’
0x30
‘0’
0x30
Control command
(ASCII string)
(CR)
0x0d
Data length 1 byte 1 byte Undened length 1 byte
f Example: The projector is powered on
“00001” (CR)
r Error response
String Details
Termination
symbol
Message
“ERR1” Undened control command
(CR)
0x0d
“ERR2” Out of parameter range
“ERR3” Busy state or no-acceptable period
“ERR4” Timeout or no-acceptable period
“ERR5” Wrong data length
“ERRA” Password mismatch
Data length 4 bytes ― 1 byte
Note
f The projector will automatically disconnect the connection with the network right after sending the command. This is the specication based
on the security view point to prevent unauthorized operation of this product by a malicious third party. To send commands continuously,
execute the network connection request every time the command is to be sent. For details, refer to “Communication ow between server
and client” (x page 299).
Communication ow between server and client
To send/receive a command via LAN, refer to the communication ow indicated below.
Server: Projector
Client: Control device such as a computer
Connection request
Server
Client
Sending of key
Sending of command 1
Responding to command 1
Disconnection
Connection request
Sending of key
Sending of command 2
Responding to command 2
Disconnection
Session 1
Session 2