Panasonic KX-UTG200

• 5.5.5 Ethernet Port Settings (Page 276)
• 5.5.7 HTTP Settings
→ HTTP_AUTH_ID (Page 280)
→ HTTP_AUTH_PASSWORD (Page 281)
→ HTTP_ENABLE_PROXY (Page 281)
→ HTTP_PROXY_SVR_ADDR (Page 281)
→ HTTP_PROXY_SVR_PORT (Page 281)
→ WEB_LANGUAGE (Page 281)
→ WEB_SERVER_PORT (Page 282)
→ WEB_SERVER_CLOSE_TIMER (Page 282)
• 5.6.1 Call Control Settings
→ DIRECT_TRANSFER_ENABLE (Page 291)
→ DND_HARD_KEY_ENABLE (Page 292)
→ REJECT_CALL_NUMBER[1-30] (Page 292)
• 5.6.2 Telephone Settings
→ DISABLE_FACTORY_RESET_FROM_ADMIN (Page 295)
→ BLF_DATA_FROM_FLEX_KEY (Page 296)
→ DIR_CMD_FACTORY_RESET (Page 296)
→ DIR_CMD_ENABLE_EMBEDDED_WEB (Page 296)
→ DIR_CMD_ENABLE_PORT_MIRROR (Page 296)
→ DIR_CMD_DISABLE_TOUCH_SCREEN (Page 296)
→ DEFAULT_ACCESS_LEVEL (Page 297)
• 5.6.4 Distinctive Ring (Page 297)
• 5.6.6 Per Multicast Group - Multicast Paging
→ MPAGE_PORT (Page 299)
• 5.8.3 All Lines - Call Control Settings
→ SIP_PASSWD_CHECK_SPECIAL_CHAR (Page 319)
• 5.9.1 Per Line - VoIP
→ RTCP_INTVL (Page 322)
→ VAD_ENABLE (Page 326)
→ REFER_TO_USE_POUND (Page 326)
→ CNG_ENABLE (Page 326)
• 5.9.2 Per Line - Call Control Settings
→ AUTO_KEY_ASSIGNMENT (Page 337)
→ AUTO_ANS_ENABLE (Page 338)
• 5.9.3 Per Line - SIP Settings
→ REFER_TO_IP_FMT_ON_XFER (Page 353)
→ REFER_TO_IP_FMT_ON_CONF (Page 354)
→ SIP_ADD_ROUTE (Page 354)
• 5.10 Diagnostic Settings (Page 354)
396 Administrator Guide Document Version 2015-01
8.1.2 14.11.1 Software File Version 03.111