Parker Compax3 S150 V4 User Manual

Compax3 device description
Power supply plug X1 for 400 VAC devices
22 I11 T11 192-120101 N6 - March 2004
3.1.3. Power supply plug X1 for 400 VAC devices
PIN Description
1L1
2L2
3L3
4PE
Mains connection Compax3 Sxxx V4
Controller type S038 V4 S075 V4 S150 V4 S300 V4
Mains voltage
Three-phase 3*400VAC
80-480 VAC+10% / 50-60 Hz
Rated input current
6Aeff 10 Aeff 16Aeff 22Aeff
Maximum fuse rating per
device
10A (automatic
circuit breaker
K)
16 A (automatic circuit
breaker K)
25A (automatic
circuit breaker
K)
Always switch devices off before wiring them!
Dangerous voltages are still present until 5 minutes after
switching off the power supply!
3.1.4. Ballast resistor / high voltage supply plug X2 for 230VAC
devices
PIN Description
1 + Ballast resistor
2 - Ballast resistor
3PE
4 + DC high voltage supply
5 - DC high voltage supply
Caution! The connector assignment of X2 is changed!
Please note the screen printing on the front plate of the
device: this is valid

Parker Compax3 S150 V4 Specifications

General

Output Current	150 A
Control Type	Digital
Series	Compax3
Model	S150 V4
Enclosure Rating	IP20
Communication Interfaces	CANopen, RS-232, RS-485
Feedback Options	Resolver
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Relative Humidity	5 to 95% non-condensing
Operating Temperature	0 to +45 °C (32 to 113 °F)