Parker Compax3 S150 V4 User Manual

Parker EME
Setting up Compax3
I11 T11 192-120101 N6 - March 2004 59
NO STOP: I0: no STOP
START: I1: START-Signal (with edge)
A new START resumes the positioning process at the position where it was
interrupted.
Relationship between the chosen STOP function and the positioning mode
A START flank after previous STOP produces:
- on condition that no STOP (E0=24V) is still present -
Single positioning Sequential positioning
STOP and termination of
the current positioning
procedure
(STOP with termination)
The positioning data record
address is read in and the
positioning data record is
executed.
Note: In continuous mode a
complete positioning, starting
from the current position, takes
place to the target position
contained in the data record.
The positioning data
record address is read in
and a new sequential
positioning procedure is
started.
STOP and interruption of
the current positioning
procedure (STOP
without termination)
The positioning procedure which was active before the STOP
is continued irrespective of the set positioning data record
address.
4.1.9.2 Define positioning data records
t
t
t
t
1
2
3
5
4
Overview:
Positioning data
record:

Parker Compax3 S150 V4 Specifications

General

Output Current	150 A
Control Type	Digital
Series	Compax3
Model	S150 V4
Enclosure Rating	IP20
Communication Interfaces	CANopen, RS-232, RS-485
Feedback Options	Resolver
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Relative Humidity	5 to 95% non-condensing
Operating Temperature	0 to +45 °C (32 to 113 °F)