10
96 Workshop Manual, TPD 1377E, issue 4
100 Series
Oil pressure switch
To remove and to fit Operation 10-6
Special requirements
Powerpart Platelock must be applied to the thread (A1) when the oil pressure switch is fitted to the cylinder
block.
Oil pressure switch range of operation 19,3 - 39,3 KPa (2.8-5.7 lbf/in²).
POWERPART products
Torque Nm (lbf ft) kgf m
Description Part number
Platelock 21826039 Oil pressure switch 11 (8) 1,1
1
This document has been printed from SPI². Not for Resale
To Next Page
Loading...
