3
28 Workshop Manual, TPD 1377E, issue 4
100 Series
Rocker shaft (103-13, 103-15, 104-19, 104-22)
To dismantle, to inspect and to assemble Operation 3-4
Special requirements
Note: Be aware of the position of the shaft location recess (A1).
Engine model
Diameter (A) mm (in)
Standard Service limit
103-13, 103-15 11,65 - 11,67 (0.4587 - 0.4595) 11,57 (0.4555) max
104-19, 104-22 14,95 - 14,97 (0.5886 - 0.5894) 14,87 (0.5854) max
Engine model
Clearance (B1) mm (in)
Standard Service limit
103-13, 103-15 0,032 - 0,068 (0.00126 - 0.00268) 0,2 (0.008) max
104-19, 104-22 0,030 - 0,093 (0.00120 - 0.00366) 0,2 (0.008) max
1
1
This document has been printed from SPI². Not for Resale
To Next Page
Loading...
