12
106 Workshop Manual, TPD 1377E, issue 4
100 Series
Coolant pump
To remove and to fit Operation 12-2
Special requirements
Notes:
On assembly apply Powerpart silicone RTV sealing and jointing compound to the cylinder block of 102-05,
103-07 and 103-10 engines.
A small amount of leakage of coolant across the surface of the face seal in the coolant pump is normal. Its
purpose is to provide lubrication for the seal. There is a hole in the coolant pump body to allow coolant to
drain. Small amounts of coolant might be seen intermittently from the drain hole during the engine operation
cycle.
Signs of a coolant through the drain hole are not an indication that the pump is faulty. Coolant stains or
intermittent drops of coolant from the hole, indicate normal operation of the pump.
Continued
POWERPART products
Description Part number
Silicone RTV sealing and jointing compound 1861108
A
POWERPART silicone
gasket sealant
102-05
103-07
103-10
This document has been printed from SPI². Not for Resale
To Next Page
Loading...
