Workshop Manual, TPD 1377E, issue 4 91
10
100 Series
Lubrication system 10
Oil filter canister
To remove and to fit Operation 10-1
1 Remove the filter canister with a strap wrench or a similar tool and then discard the canister.
2 Clean the seal face of the filter head.
3 Lubricate the seal of the new canister with clean engine oil before assembly.
4 Install the new canister and tighten it by hand only. Do not use a strap wrench.
5 Tighten the canister by a further ½ to ¾ of a turn by hand only.
6 After the lubricating oil has been added to the sump, operate the engine and check for leakage from the
filter. When the engine has cooled, check the oil level on the dipstick and add oil to the sump, as necessary.
Caution: Do not use a strap wrench to tighten the filter canister.
This document has been printed from SPI². Not for Resale
To Next Page
Loading...
