Piper Dakota - Page 286

LIST OF ILLUSTRATIONS
FIGURE NO. SUBJECT GRID NO.
21-15. Components Installation 1H3
21-16. Overhead Vent System (Not Available with
Air Conditioning) 1H5
23-1. Avionics Master and Emergency Switch Circuit 1H14
23-2. Communications Components ELT Schematic 1H16
23-3. Emergency Locator Transmitter Schematic (Narco) 1H16
23-4. ELT Portable Folding Antenna (Narco) 1H18
23-5. ELT Using Fixed Aircraft Antenna (Narco) 1H18
24-1. Lamp-Bank Load 1I10
24-2. Exploded View of Alternator (Chrysler) 1I12
24-3. Checking Field Coil Current Draw 1I12
24-4. Testing Field Circuit 1I12
24-5. Testing Positive Rectifiers 1I14
24-6. Testing Negative Rectifiers 1I14
24-7. Rectifier End Shield and Stator Assembly 1I14
24-8. Testing Positive Rectifiers With Test Lamp 1I16
24-9. Testing Negative Rectifiers With Test Lamp 1I16
24-10. Rectifier and Heatsink Assembly Removal 1I17
24-11. Rectifier End Shield Assembly 1I17
24-12. Testing Stator 1I18
24-13. Removal of Pulley 1I18
24-14. Removal of Bearing 1I19
24-15. Removal of Rectifier End Shield Bearing 1I19
24-16. Testing Rotor for Ground 1I20
24-17. Testing Rotor for Opens or Shorts 1I20
24-18. Installation of Grease Retainer 1I21
24-19. Installation of Rectifier End Shield Bearing 1I21
24-20. Installation of Drive End Shield Bearing 1I21
24-21. Installation of Pulley 1I21
24-22. Installation of Insulators 1I23
24-23. Installation of Positive Rectifier Assembly 1I23
24-24. Installation of Capacitor 1I23
24-25. Installation of Battery Output Insulator 1I23
24-26. Installation of Negative Rectifier Assembly 1Jl
24-27. Installation of Stator 1JI
24-28. Exploded View of Alternator (Prestolite) 1J3
24-29. Removal of Slip Ring End Bearing 1J4
24-30. Removal of Rectifier 1J4
24-31. Removal of Drive End Head 1J4
24-32. Removal of End Head Bearing 1J4
24-33. Testing Rotor for Ground 1J5
Introduction
Page - 9
Reissued: August 1, 1986
2A10
PIPER AIRCRAFT
PA-28-236
MAINTENANCE MANUAL