Piper Dakota - Page 287

LIST OF ILLUSTRATIONS (cont)
FIGURE NO. SUBJECT GRID NO.
24-34. Testing Rotor for Shorts 1J5
24-35. Installation of Bearing 1J7
24-36. Installation of Rectifier 1J7
24-37. Terminal Assembly 1J7
24-38. Slip Ring End Bearing Assembly 1J8
24-39. Testing Alternator 1J8
24-40. Brush Installation 1J9
24-41. Internal Wiring Diagram 1J9
25-1. Seat Back Lock 1J19
27-1. Rod End Installation Method 1K7
27-2. Control Column Assembly 1K9
27-3. Aileron Controls (Typical) 1K12
27-4. Aileron Rigging 1K16
27-5. Bellcrank Rigging Tool 1K16
27-6. Aileron Rigging Tool 1K17
27-7. Rudder and Steering Pedal Assembly 1K19
27-8. Rudder Controls 1K21
27-9. Rudder Rigging Tool 1K22
27-10. Clamping Rudder Pedals 1K22
27-11. Rudder Rigging 1K22
27-12. Rudder Travel Adjustments 1L2
27-13. Rudder Trim Control 1L2
27-14. Stabilator Controls 1L4
27-15. Stabilator and Stabilator Trim Travel Adjustments 1L5
27-16. Stabilator Rigging Tool 1L5
27-17. Methods of Securing Trim Cables 1L8
27-18 Stabilator Trim Control 1L9
27-19 Flap Controls 1L13
27-20. Flap Step Adjustment 1L15
27-21. Flap Rigging Tool 1L15
27-22. Flap Rigging 1L18
28-1. Fuel System Diagram 2A20
28-2. Locking Fuel Cap Assembly 2A24
28-3. Fuel Filter Bowl and Screen 2B2
28-4. Plunger Fuel Pump 2B2
28-5. Tolerances, Union Nut and Tubing Nut 2B6
28-6. Fuel Gauge 2B9
32-1. Main Gear Oleo Strut Assembly 2B17
32-2. Main Gear Installation 2B19
32-3. Nose Gear Oleo Strut Assembly 2B21
32-4. Nose Gear Installation 2C1
32-5. Clamping Rudder Pedals in Neutral Position 2C3
32-6. Rudder Pedals at Neutral Angle 2C3
Introduction
Page - 10
Reissued: August 1, 1986
2A11
PIPER AIRCRAFT
PA-28-236
MAINTENANCE MANUAL