All-New Event Presentation Switching Solutions
User Manual
In switcher mode, connector 1 works as primary connector for 4K output and
connector 5 copies connector 1.
In PGM only mode, connectors 1 and 5 can work as primary connectors and have
the same resolution.
SL:
In switcher mode, connectors 1 to 4 work as primary and connectors 5 to 8 copy
connectors 1 to 4, respectively. Connectors 1, 2, 3 and 4 have the same resolution.
In PGM only mode, eight connectors work as primary. All the connectors have the
same resolution.
Control Connectors
The P10 provides two Ethernet ports and a Genlock connector with loop-through.
Ethernet
Two Ethernet ports are used for control and live input view (One works as primary
and the other as backup. They share the same IP address.).
Genlock IN & LOOP
Genlock synchronization signal connectors are provided.
GENLOCK IN: Synchronization signal input
GENLOCK LOOP: Synchronization signal loop output
Power Connector and Switch
Power connector: 100-240V~, 3.0-1.5A, 50/60Hz
Power switch:
− ON: Power on
− OFF: Power off
Specifications of input and output video connections
DP 1.2
− Maximum resolution: 4096×2160@60Hz/8192×1080@60Hz
− Minimum resolution: 800×600@60Hz
− Maximum width: 8192 pixels (8192×1080@60Hz)
− Maximum height: 8192 pixels (1080×8192@60Hz)
− Maximum frame rate: 120 Hz
− EDID management (support for standard resolutions and custom resolutions)
− HDCP 1.3 compliant
HDMI 2.0
− Maximum resolution: 4096×2160@60Hz/8192×1080@60Hz
− Minimum resolution: 800×600@60Hz
− Maximum width: 8192 pixels (8192×1080@60Hz)
− Maximum height: 8192 pixels (1080×8192@60Hz)
To Next Page
Loading...