Quantum SPARK 1500 - Page 323

Configuring Remote Access Users
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|323
To add a new local user with remote access permissions:
1. Click Add > New Local User.
2. In the Remote Access tab in the window that opens, enter this information:
n
User name
n
Password - Enter this again in the Confirm field.
Note - The password can be up to 100 characters.
n
Comments (optional)
3. For temporary or guest users, click Temporary user.
Enter the expiration date and time.
4. Do not clear the Remote Access permissions checkbox.
5. In the SSL VPN Bookmarks tab, configure the SSL VPN bookmarks (see below).
6. Click Apply
The user is added to the table on the page.
To add a new local users group with remote access permissions:
1. Click Add > New Users Group.
2. In the Remote Access tab, enter the group name.
3. Do not clear the Remote Access permissions checkbox.
4. Select initial users to add to the group by clicking the relevant checkboxes from the user
list or click New to create new users.
You can see a summary of the group members above the user list. You can remove
members by clicking the X next to the relevant user name.
5. In the SSL VPN Bookmarks tab, configure the SSL VPN bookmarks (see below).
6. Click Apply
The group is added to the table on the page.