Configuring Remote Access Users
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|324
To add remote access permissions to an existing Active Directory group:
1. Click Add > Active Directory Group.
2. If no Active Directory was defined, you are prompted to configure one. For more
information on configuring Active Directory see VPN > Authentication Servers.
3. When an Active Directory has been defined, you see a list of available user groups
defined in the server.
4. Select one of the user groups.
5. Click Apply
The Active Directory group is added to the table on the page.
To add remote access permissions to all users in defined in an Active Directory:
1. Click Edit Permissions or Add > Active Directory Permissions.
2. Select All users in Active Directory. With this option, it is not necessary to use the VPN
> Remote Access Users page to select specific users.
Note that most Active Directories contain a large list of users and you might not want to
grant them all remote access permissions to your organization. Usually you keep the
Selected Active Directory user groups option.
3. Click Apply
The Active Directory is added to the table on the page.
To Next Page
Loading...
