Managing the Device
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|78
iii. Select Monitor connection state by sending probe packets to one or
more servers on the Internet to detect connectivity loss by using more
methods and servers.
Important - In versions R81.10.10 and higher, it is supported to
disable probing in an Internet connection only if you clear the
option, "This Internet connection will be a part of SD-WAN" (on
the "Advanced" tab > section "SD-WAN Settings").
iv. In the Connection probing method section, select one of these:
n
Ping addresses - To send pings to the servers configured on this tab
(enter an IP address or a hostname).
n
Probe DNS servers - To send pings to the DNS servers you
configured on the Configuration tab.
d. Configure the required settings on the Advanced tab:
Procedure
Note - Based on the selected connection type on the Configuration tab,
different sections and options appear.
In the IP Address Assignment section (for PPPoE, PPTP, or L2TP), configure
the applicable settings.
Configuration
n
Local tunnel IP address
Configures how this Internet connection (PPPoE, PPTP, or L2TP) gets
its local IP address - automatically or uses the configured IP address.
n
Unnumbered PPPoE
Controls whether the appliance dials only one time and supports a range
or IP addresses assigned by an ISP.
n
WAN IP assignment
Configures how this Internet connection (PPTP or L2TP) gets its WAN IP
address - automatically or uses the configured IP address, Subnet mask,
and Default gateway.
To Next Page
Loading...
