Quantum SPARK 1500 - Page 79

Managing the Device
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Locally Managed Administration Guide|79
In the Service Provider Assignment section (for PPPoE, PPTP, or L2TP),
configure the applicable settings.
Configuration
n
Service
Optional. Configures a name for the dial service name.
n
Authentication method
Configures the authentication method for the dial service (Auto, PAP,
CHAP).
In the Connect on demand section (for PPPoE, PPTP, or L2TP), configure the
applicable settings.
Configuration
Connect on demand
Controls whether to use the connect-on-demand feature.
Applies only when you are in a High Availability cluster of appliances.
In the Port Settings section, configure the applicable settings.
Configuration
n
If necessary, select Use custom MTU value and configured the MTU
size value.
You can apply an MTU on:
l
LANs and DMZ – They must be separate networks, or assigned to
a bridge network.
l
Switches - The MTU is assigned to the switch itself, not the LANs
that are assigned to it.
l
Bonds
l
VLANs - The VLAN MTU must be lower or equal to its parent MTU.
You cannot apply an MTU on:
l
Interfaces assigned to switches or bonds.
l
Bridges - Configure the MTU separately for each of their children.
l
Aliases
l
Virtual Access Points