8 Configuring the Drive System
8.1 General Information
Within the Rexroth IndraDrive product range, it is possible to combine com‐
ponents of the following subranges:
● Rexroth IndraDrive C
● Rexroth IndraDrive M
● Rexroth IndraDrive Mi
You have to select:
Type of supply
● Supply units
● Converter
● Type of mains connection
Additional component mains filter
Other additional components for mains connection
Drive
● Motors with measuring systems
● Power sections
● Control sections with options
● Firmware for selected power sections with control section
Additional Components
● For the DC bus
● For the motor output
Cables
● For power supply to the motor
● For signal evaluation from motor to control electronics
8.2 Type of Supply for Power Sections
8.2.1 General Information
The requirements to the individual axes are known from the drive task and
the appropriate drive controllers - the drive system - have been selected for
this purpose. For this drive system, select the appropriate supply. The follow‐
ing list will be explained in detail in this chapter:
● Supply by HMV supply unit
– In central supply
– In parallel operation
● Supply by HCS converter
– In central supply
– In parallel operation
● Supply by third-party supply units
– RD500 - SFT converter
DOK-INDRV*-SYSTEM*****-PR06-EN-P
Rexroth IndraDrive Drive Systems with HMV01/02 HMS01/02, HMD01, HCS02/03
Bosch Rexroth AG 93/309
Configuring the Drive System
To Next Page
Loading...
