1001 Bit Switch
011 Bit Switch B 0 1
bit 0 DFU - -
bit 1
Print job interruption
0: Does not
allow
interruption
1: Allow
interruption
0 (default): Print jobs are not interrupted. If a job is promoted to the top of the print
queue, it will wait for the currently printing job to finish.
1: If a job is promoted to the top of the queue, it will interrupt the currently printing
job and start printing immediately.
bit 2 Switch for enabling or disabling Limitless Paper
Feeding for the Bypass Tray
0: Enable 1: Disable
When the Bypass Tray is the target of the Auto Tray Select and Any Size/Type is
configured for the Tray Setting Priority setting of the Bypass Tray, this Bit Switch can
switch the behavior whether or not Limitless Paper Feeding is applied to the Bypass
Tray.* The default is Enabled (=0).
*Limitless Paper Feeding will try a matching tray of the next highest priority if a job
specified to Auto Tray Select as the tray setting is submitted and the tray runs out of
paper.
Enabled (=0: Default):
Limitless Paper Feeding is applied to the Bypass Tray.
If a tray other than the Bypass Tray matches the job's paper size and type but has run
out of paper, printing will occur from the Bypass Tray.
Disabled (=1):
Limitless Paper Feeding is not applied to the Bypass Tray.
If a tray other than the Bypass Tray matches the job's paper size and type but has run
out of paper, printing will stop and an alert will appear on the LCD screen, stating
that the tray has run out of paper. This prevents unexpected use of the Bypass Tray.
Limitations when this Bit Switch is set to "1":
- The "Paper Tray Priority: Printer" setting must be configured to a tray other than the
Bypass Tray.
- Jobs that contain more than one paper size cannot be printed.
5. System Maintenance Reference
264
To Next Page
Loading...
Need help?
General
