bit 4 Add "Apply Auto Paper Select" is the condition
that decides if the device's paper size or paper
type should be overwritten.
0: Disable 1: Enable
If this Bit Switch is set to "1" (enable), the "Apply Auto Paper Select" setting will
decide if the paper size or paper type that is specified in the device settings should
be overwritten by the job's commands when "Tray Setting Priority" is set to "Driver/
Command" or "Any Type".
- Apply Auto Paper Select = OFF: Overwritten (priority is given to the job’s
commands)
- Apply Auto Paper Select = ON: Not overwritten (priority is given to the device
settings)
bit 5 DFU - -
bit 6 DFU - -
bit 7 DFU - -
1001 Bit Switch
012 Bit Switch C DFU - -
1003 [Clear Setting]
1003 001 Initialize System Initializes settings in the System menu of the user
mode.
1003 003 Delete Program DFU
1004 [Print Summary]
1004 001 Service Summary Prints the service summary sheet (a summary of all
the controller settings).
1005 [Display Version]
1005 002 Printer Version Displays the version of the controller firmware.
1007 [Supply Display]
Enables or disables the display for information on each consumable supply.
Service SP Mode Tables
265
To Next Page
Loading...
Need help?
General
