5-816-002 CE Call *CTL [0 or 1 / 0 / 1/step]
0: Start of the service
1: End of the service
Performs the CE Call at the start or end of the service.
• This SP is activated only when SP 5816-001 is set to “2”.
5-816-003 Function Flag *CTL [0 or 1 / 0 / 1/step]
0: Disabled, 1: Enabled
Enables or disables the remote service function.
5-816-007 SSL Disable *CTL [0 or 1 / 0 / 1/step]
0: No. SSL used.
1: Yes. SSL not used.
Controls if RCG (Remote Communication Gate) confirmation is done by SSL during an
RCG send for the @Remote over a network interface.
5-816-008 RCG Connect Timeout *CTL [1 to 90 / 30 / 1second/step]
Sets the length of time (seconds) for the time-out when the RCG (Remote
Communication Gate) connects during a call via the @Remote network.
5-816-009 RCG Write Timeout *CTL [0 to 100 / 60 / 1second/step]
Sets the length of time (seconds) for the time-out when sent data is written to the RCG
during a call over the @Remote network.
5-816-010 RCG Read Timeout *CTL [0 to 100 / 60 / 1second/step]
Sets the length of time (seconds) for the timeout when sent data is written from the RCG
during a call over the @Remote network.
5-816-011 Port 80 *CTL [0 or 1 / 0 / 1/step]
0: No. Access denied
1: Yes. Access granted.
Controls if permission is given to get access to the SOAP method over Port 80 on the
@Remote network.
Engine SP Mode Tables - SP5000
439
To Next Page
Loading...
Need help?
General
