FX-20
10.4 FASST FREQUENCY MODE SELECTION-7 CHANNEL
/ MULTI
The transmitter can be operated in 2 different modulation
modes: FASST MULTI (8+2 channels) and FASST 7 CH (1-7
channels). The modulation mode in use will be shown in the
lower left area of the main start display.
1. To change modulation mode either select the MULTI/ 7CH
in lower left area of the Start display or from “FREQUENCY”
in Linkage menu.
2. Move the cursor to the required modulation mode and
select your choice. The modulation mode will be automati-
cally stored in the active model memory.
For the different FASST 2,4 GHz receivers, the following
modulation modes are selected, regardless of number of
channels actually used or required:
FASST MULTI: 8+2 Channel Mode, Receiver models R608FS,
R6008HS, R6014FS and R6014HS.
FASST 7CH: 7 Channel Mode, Receiver models R606FS,
R607FS, R617FS, R6004 FF and R6106 F/C
Selection of the FASST 7CH modulation mode will display 8
or more channels in different menus (Servo centring, Servo
reverse etc.). But adjustments can only be made for the chan-
nels 1-7.
10.5 CHANGING FASST AREA FREQUENCY BAND
Select “FREQUENCY” in Linkage Menu and access set up
screen.
You will be asked which frequency band is to be selected: Ge-
neral or France.
Information about selecting frequency range in the 2,4
GHz Band.
Operating areas: EU countries, Switzerland, Norway, Iceland,
Russia. There are 2 frequency ranges that may be used in 2,4
GHz Band.
1. 2400...2483,5 MHz, Switch position “General“.
This frequency range is not allowed in every EU-country
(un-harmonized), e.g. France, that is why the “CE “ mark
is followed with a “!”. Furthermore, the manufacturer regi-
sters this equipment with the relevant national authorities.
To be able to be used on this frequency band, and due to
the different frequency regulations, different national rules
apply for the use of the 2,4 GHz band or the radiated power
permitted.
2. 2400...2454 MHz, Switch Position “France“.
This frequency range is harmonized throughout the EU,
with conformity declaration „CE“. Therefore, no notification
is required to be made with the national authorities and
there are no national limitations in force.
Recommendation:
For countries such as Austria, France, Russia, Italy and Bel-
gium, select the frequency range 2 (2400...2454 MHz) “France”
Romania and Bulgaria require an additional general permission
and you should contact your local authorities for more informa-
tion. In Norway, this equipment may not be operated within a
20 km-radius of the Ny Aelesund research station.
Important:
After changing frequency band from “GENERAL” to “FRANCE”,
the receiver must be “re-bound”. Following the required selec-
tion, confirm the frequency change. Selecting “NO” the radiated
power remains turned off and can always be switched on later.
IMPORTANT: Make a thorough range test before the first
take-off!!
27
Linkage Menu
To Next Page
Loading...