FX-20
CONNECTION TO S-BUS OUTPUT
Up to 18 (16 prop channels, 2 switching channels) of the new,
programmable S-BUS servos can be connected in parallel di-
rectly to this output. Using digital addressing, the servo will only
react to information which has the correct servo address
To use the S-BUS output, connect corresponding S-BUS ser-
vos via the S-BUS HUB No. F1697 or No. F1698 or V-lead No.
F1423 to the S-BUS connection at the receiver.
Note: Individual S-BUS servos can also be connected di-
rectly.
MIXED CONNECTION
Note:
The maximum S-BUS channel count is 16+2. However, only
the same number of channels as the transmitter posesses are
available for use (currently 8+2 or 12+2).
Important:
A battery connected directly to the receiver can make available
current at 3 A permanently and 6 A short-term.
A second battery connection should be made on to the connec-
tor strip of the receiver for higher power requirements. The cur-
rent carrying capacity of the receiver increases from 5A to 10
A continuous. Further power connection for S-BUS are under
preparation.
We recommend the use of the battery switch PSS 2018 No.
F1660 for higher currents!
Hubcable 30 cm No. 88830030
HUB-4 with power current conection No. 8884
Accessories:
The S-BUS PWM adapter No. F1695 makes it possible to use
the new S-BUS system in existing models and servos. Adap-
ter to connect 3 standard servos to the S-BUS. The signal is
converted for each individual outputfrom S-BUS to PWM. The
outputs can be configured with e the same or different chan-
nel numbers. Channel number allocation is made either using
a PC with the PC LINK software, or independent from the PC
using the handy S-BUS programmer SBC-1.
7
General
S-Bus
Connec-
tion
Hubcable No. F1697
max. curent 3A / 6 A continuous
max. curent 6A / 12 A continuous
max. current 6 A / 12 A continuos
To Next Page
Loading...
