101
Software
D
D
7.1.2. Assigning Access Rights
The user is normally denied access rights to certain areas, e.g., administration of user accounts and sensitive
system functions (focus adjustment etc.). The user, therefore, cannot access all of the menus on the Control
Center after login.
Access rights can be modifi ed at any time by the Administrator. Rights are generalized in user roles that can
comprise a single access right or a set of access rights. To grant rights you will need to assign one or more user
roles to a user. The following user roles are available after installation of the software:
Administrator
Production Staff
Research Staff
Superuser
Support
By default, the pre-installed Production Staff, Research Staff and Support roles have no functions assigned to
them. More detailed information about creating functions for each pre-set user role, as well as editing existing
functions and creating new user roles, can be found under “Creating and Editing User roles”.
Follow the instructions below to assign rights to a user account:
1
Click on the Setup menu in the Cedex Control Center.
2
Click on User and Rights management, and the User Rights Management window will appear.
3
In the All Users main menu open the user account menu that is to be modifi ed. A User Role sub-menu will
appear.
4
Open the All Roles main menu and drag the appropriate user role from the All Roles menu into the All
Users sub-menu. The access rights available for this user role will be added to the account. To deny certain
access rights, the corresponding user role needs to be deleted from the All Users sub-menu. Right click the
user role which is to be deleted and click on Remove the role from the user.
■
Figure 72: User Rights Management area
Administrator Functions
Administration of User Accounts
To Next Page
Loading...
