Roche Cedex HiRes - Working with the Multi Sampler

50
Cedex HiRes Analyzer Operator’s Guide
C
C
3 Carrying out a Single Measurement
The following section describes the procedure for carrying out a single measurement. For setting up and
carrying out multiple measurements, see “Working with the Multi Sampler”.
A number of relevant parameters and entries must be specifi ed in the Measurement window prior to carrying
out measurements. They include:
 Choosing the operating mode and specifying sample data.
 Defi ning the measurement and analysis (process) parameters.
The measurement procedure can only begin when the steps above have been completed.
Perform a HW Startup and Prime prior to the fi rst measurement if the Liquid and Hardware Management
system were previously shut down (see “Performing a HW Startup and Prime”).
Carrying out a Single Measurement