76
Cedex HiRes Analyzer Operator’s Guide
D
D
3 Editing Existing Analysis Results/ Data Sets
The Cedex HiRes Software 2.2 allows for existing measurement results or data sets to be modifi ed and
reprocessed. These changes are done on existing software data (image and analysis results) and, therefore, do
not require any adjustments to the analyzer. Existing measurement results can be edited via the Reprocess
button in the lower right-hand corner of the Measurement List window.
3.1 The Reprocess Button
Reprocessing existing measurement results/data sets, i.e. viewing a set of image data and evaluating them with
new analysis parameters, can be done in the Reprocess mode, which is only accessible to authorized system
users.
The reprocess mode offers the following options:
Enter, modify or delete a comment.
Correct the dilution (see “Defi ning the Measurement and Analysis (Process) Para meters”).
Change the Cell Type (see “Adjustment of the Image Analysis using the Live Operator”).
To reprocess a measurement, do the following:
1
Open the Measurement List window by clicking on the List button in the Shortcuts area of the Cedex
Control Center or by selecting the Measurement List option in the Measurements menu of the Control
Center.
2
Highlight the row of the measurement to be reprocessed and click on the Reprocess button in the lower
right-hand corner. A Measurement window will open containing all of the result data for that measurement.
3
Enter a new name for the data set in the DataSet section of the Sample Parameters area.
4
Make the desired changes to the new data set. Changes can be made with regard to the comment, dilution
factor and Cell Type in the appropriate sections of the Sample Parameters and Processing Parameters areas.
5
Click on the Reprocess button in the center of the Measurement window to start the reprocessing of the
measurement based on the new parameters.
6
When the reprocessing is fi nished a window will open asking whether the new data set should be the
effective data set (see “
Effective Data Sets”).
■
A new data set is available once the evaluation has been completed. All changes can be retraced by viewing pre-
viously created data sets, which are shown in the Measurement List window.
The reprocessing procedure creates additional data sets. Original data is not overwritten.
Editing Existing Analysis Results/Data Sets
The Reprocess Button
To Next Page
Loading...
