90
Cedex HiRes Analyzer Operator’s Guide
D
D
5.2.1. The Data Selection Area
Which curves should be displayed in the diagram is determined in the Data Selection area of the Cultivation
Time Chart window. The following values can be selected for display:
Viable Cell Conc.: Viable cell concentration[cells/ml]
Total Cell Conc.: Total cell concentration [cells/ml]
Viability [%]: Percent viability
Total Cell Count: Total number of all cells counted
Avg. Compactness: Average compactness of living cells [without unit]
Avg. Diameter: Average diameter of living cells [µm]
Std. Dev.: The deviation from image to image of the number of cells found in each image
Aggregate Rate [%]: Percent of cells found in aggregates
Dead Cell Conc.: Dead cell concentration [cells/ml]
Viable Cell Count: The total number of viable cells counted
Dead Cell Count: The total number of dead cells counted
Total Object: The total number of objects counted
Click on the appropriate checkboxes to select the desired values.
Figure 66: Cultivation Time Chart window
The measurement series, including information about which measurements have been used to create the chart,
are listed in the Data Series area in the bottom left-hand corner of the Cultivation Time Chart window. A
legend indicating the symbol (form and color) used for each parameter is at the top of the graph. The color used
for each series is indicated in the Chart area in the lower right-hand corner of the window.
The x-axis units can be displayed as either days [d] or hours [h]. Click on the Time[d] below the x-axis to switch
to hours. The x-axis calibration will be automatically recalculated.
If the mouse pointer is placed over a measurement point in the diagram, detailed information, including the
date and time of the measurement as well as the results, will be displayed next to the point. Also, the graphic
representation can be enlarged or scaled down again with the use of the mouse (see “Enlarging the Diagrams”).
Cultivation Time Chart
Creating a Cultivation Time Chart