64
Cedex HiRes Analyzer Operator’s Guide
C
C
4.6 Results
After a Multi Run has fi nished, the results for all measurements obtained by the Cedex HiRes System are stored
and displayed as described in “Using the Measurement List”. In addition, some results for the measurements
carried out are displayed in the Analyzed Measurements fi eld at the bottom of the Multi Run window.
4.6.1. The Multi Run Result List
At the bottom of the Multi Run window, the Analyzed Measurements fi eld displays the list of results for
measurements previously carried out. Measurements are listed in order of process time, from the newest
measurements at the top of the list to the oldest measurements at the bottom. All measurements carried out
using the Multi Run window will be displayed in this fi eld unless the Clear Resultlist button has been pressed.
Clicking on the Clear Resultlist button will clear all measurement results from the list. In addition, measurements
displayed in this fi eld can be restricted to only the measurements carried out by the user logged into the system
(mine), measurements that have not yet been printed out (unprinted), and/or measurements carried out on
that particular day (today).
Measurement results can be printed out via the Print Report button located just above the Analyzed
Measurements fi eld (see “Printing Reports” for more information about print report options).
The following information is, by default, shown in the result list:
User
Workarea
Reactor ID (classifying the cell sample)
Sample ID (naming the measurement)
Valid check-box
Total cell concentration [× 10
5
cells/ml]
Viable cell concentration [× 10
5
cells/ml]
Viability [%]
Sample Drawing (defi ned by user, if desired)
Process Time (date and time sample was measured)
Comment (if added by the user)
Other results, such as Average Diameter, can be added for display in the result list via the User Preferences (see
“Adjusting Result Display in the Measurement List and Multi Run windows”). Double-click on a measurement
to view all results. If the result list has been cleared, previously carried out measurements can still be viewed,
printed out and exported via the Measurement List window (see “Using the Measurement List”).
Working with the Multi Sampler
Results
To Next Page
Loading...
