Roche Cedex HiRes - Editing Measurements in a View; Viewing List of Measurements in a Series

88
Cedex HiRes Analyzer Operator’s Guide
D
D
5.1.4. Editing Measurements in a View
Measurements can be added or removed from a particular View by using the Edit button in the Series belonging
to the selected view area of the CTC Views window. To edit the measurements found in a View, do the following:
1
Highlight the row of the View to be edited in the View area of the CTC Views window.
2
Highlight the particular series of a View to be edited in the Series belonging to the selected view area.
3
Click on the Edit button. This will open the Selection of Data Series window (see Figure 64).
4
Add or remove measurements from the series list by highlighting the measurements and clicking on the
Remove button at the bottom of the window.
5
Click on the Save button. The changes will be saved and the window will automatically close.
6
The CTC Views window will become available and other series in the same View or else other Views can
now be edited.
■
Measurements can also be excluded from a cultivation time chart without being removed from the series. All
measurements selected for a series that are marked with a (✔) in the checkbox of the Use column will be
displayed in the Cultivation Time Chart. Should it not be desirable to display a particular single measurement,
the measurement can be unselected by removing the (✔) in the Use column with a mouse click.
5.1.5. Viewing List of Measurements in a Series
If measurements have been added to a View, a simplifi ed list of the series will appear in the left-hand side of the
Series belonging to the selected view area of the CTC Views window. To see the full list of all measurements
from all series created, click on the List button. This will open the Series List window (see Figure 65). A search
for specifi c measurements in the list can be done using the Filter By area in the upper right-hand corner of the
Series List window. Searches can be made by Workarea, Reactor ID or date of measurement. Once the fi lter
parameters have been set, click on the Find button. The measurements that fi t the parameters will be displayed
in the Measurements area in the lower left-hand corner. Only series that contain measurements with the correct
parameters will be displayed in the Series area in the upper left-hand corner of the Series List window.
Figure 65: Series List window
Cultivation Time Chart
Creating a CTC View