Roche Cedex HiRes - Updating Older Cedex HiRes Software version 2.x to Cedex HiRes Software 2.2

34
Cedex HiRes Analyzer Operator’s Guide
B
B
4.3 Updating Older Cedex HiRes Software version 2.x to Cedex HiRes
Software 2.2
4.3.1. Overview
Before starting an update of your current Cedex HiRes Software 2 installation to Cedex HiRes Software version
2.2, ensure that:
 You have Administrator access to the computer.
 The Firebird database password (i.e., of the SYSDBA account) is available in case it has been changed, e.g.,
because the installation has been made 21 CFR Part 11 compliant.
 A storage device with enough disk space is available for a backup of the current installation. A storage device
with enough disk space is available for a backup of the current installation. Check the size of the folder
containing all Cedex Software 2 fi les, including the database fi le (usually the directory C:\Cedex2). The size
of the backup will be approximately the size of this folder.
 Enough time is scheduled for a backup of the current installation (approximately one hour for backup to a
fast external hard drive per 10 GB disk space used in the Cedex 2 directory, including the database fi le).
4.3.2. Updating to Cedex HiRes Software 2.2
Make sure that you have created a backup of the Cedex HiRes Database and that you have fully read and
understood the following instructions before proceeding with the update of the Cedex HiRes Software! If an
error occurs or if you do something wrong, this could result in data loss and/or could prevent the Cedex HiRes
Software 2.2 from operating!
1
Run the Cedex 2.2.1.exe from the install CD by double-clicking on it.
2
If the Firebird database software is not up to date, the following dialog will appear:
Figure 19
Should the dialog appear, confi rm it with OK to update the Firebird database software:
Figure 20

Installing Cedex HiRes Software 2.2 or Updating to Cedex HiRes Software 2.2
Updating Older Cedex HiRes Software version 2.x to Cedex HiRes Software 2.2