Roche Cedex HiRes - Deleting Views and Series; Exporting a View; Creating a Cultivation Time Chart

89
Software
D
D
5.1.6. Deleting Views and Series
Entire Views can be deleted by highlighting the View and clicking on the Delete button in the View area of the
CTC Views window. If one series of a particular View should be deleted, highlight the relevant View in the View
area, then highlight the series to be deleted in the Series belonging to the selected view area. Click on the Delete
button in the Series belonging to the selected view area of the CTC Views window.
5.1.7. Exporting a View
The series of measurements in a view can be exported via the Export button in the CTC Views window. Select
the View to be exported in the View area of the CTC Views window and click on the Export button. An Export
window will open in which the desired settings and parameters can be selected (see “
Export to fi le”).
5.2 Creating a Cultivation Time Chart
Once a View has been created with the desired series of measurements to be used for a chart, the Cultivation
Time Chart can be created. To create a Cultivation Time Chart, do the following:
1
Highlight the View to be used for the creation of a Cultivation Time Chart in the CTC Views window.
2
Click on the View Chart button, this will open the Cultivation Time Chart window (see Figure 66).
3
Select the parameters to be displayed in the chart by clicking on the desired parameters in the Data
Selection area in the upper right-hand corner of the window (see “
The Data Selection Area”).
4
Select the series to be displayed in the Chart area in the lower right-hand corner of the window.
5
A graph will then be generated showing the selected parameters and series.
■
Only measurements already loaded will be displayed in the Cultivation Time Chart window diagram. The
Selection of Data Series window must be brought up again to add additional measurements.
Cultivation Time Chart
Creating a Cultivation Time Chart