38
Cedex HiRes Analyzer Operator’s Guide
B
B
Carry out the following steps to restore the Cedex HiRes Software 2 backup that was created in step step 7 in the
chapter “
Updating to Cedex HiRes Software 2.2”:
1
Locate the active Cedex2 folder on the hard disk. It is usually located at C:\Cedex2, which is the default
location selected during installation. Delete the Cedex2 folder by right clicking on it and selecting Delete:
Figure 32
2
Confi rm the upcoming message by clicking on Ye s :
Figure 33
3
Locate the folder where the backup of the Cedex2 folder and database has been stored. Copy that folder by
right clicking on it and selecting Copy:
Figure 34
4
Navigate to the location from which the Cedex2 folder was deleted in step 1 (usually C:\). Paste the backup
in this location:
Figure 35
Installing Cedex HiRes Software 2.2 or Updating to Cedex HiRes Software 2.2
Updating Older Cedex HiRes Software version 2.x to Cedex HiRes Software 2.2
To Next Page
Loading...
