61
Operation
C
C
The Status column can display the following information (see Figure 45, above and Figure 46):
Edit: Indicates that sample data is actively open for editing and is in the process of being edited.
Sample data in edit mode has not yet been added to the process queue, and samples placed
in positions in edit mode will not be analyzed when the Multi Run is started. Rows in edit
mode are white.
Active: Indicates that the sample is ready for analysis, which starts automatically once the Start
button is pressed. Rows in active mode are highlighted light blue.
Scheduled: All rows marked as active will be added to the process queue and converted to scheduled
mode after pressing the Start button. Rows marked as edit will remain in edit mode.
Prepare: Indicates that the system is preparing to measure the sample marked with this status. The
row is highlighted in yellow.
Measure: Indicates that the system is in the middle of carrying out a measurement of the sample
marked with this status. The row is highlighted in yellow.
Cleaning: Indicates that the system is carrying out the cleaning routine after a completion of a
measurement. The row is highlighted in yellow.
Done: indicates that measurement and analysis of a sample marked with this status has been
completed successfully. The row is highlighted in green.
Failed: The measurement of this cup has failed.
Aborted: The measurement of this cup has been aborted by the user.
No Cup: There was no cup at this position in the multi sampler when it was ready for measurement.
Blocked: The lift was blocked when the cup should have been measured.
The status of a particular measurement is tracked in the Status column. The Errors and messages window gives
a list of each step completed and any errors that may have occurred.
Working with the Multi Sampler
Carrying out Measurements with the Multi Sampler
To Next Page
Loading...
