Rohde & Schwarz FSW26 - Page 1026

Remote Commands
R&S
®
FSW
1026User Manual 1173.9411.02 ─ 19
[SENSe:]CORRection:TRANsducer:ADJust:RLEVel[:STATe] <State>
This command turns an automatic adjustment of the reference level to the transducer
on and off.
Before you can use the command, you have to select and turn on a transducer.
Parameters:
<State> ON | OFF
*RST: OFF
Manual operation: See "Adjusting the Reference Level" on page 573
[SENSe:
]CORRection:TRANsducer:COMMent <Comment>
This command defines the comment for the selected transducer factor.
Before you can use the command, you have to select and turn on a transducer.
Parameters:
<Comment> *RST: (empty comment)
Manual operation: See "Comment" on page 575
[SENSe:]CORRection:TRANsducer:DATA <Frequency>,<Level>
This command defines the shape of the transducer factor.
Parameters:
<Frequency>,
<Level>
The unit for <Frequency> is Hz. Frequencies have to be sorted
in ascending order.
The unit for <Level> depends on[SENSe:]CORRection:
TRANsducer:UNIT .
Manual operation: See "Data points" on page 575
[SENSe:]CORRection:TRANsducer:DELete
This command deletes the currently selected transducer factor.
Before you can use the command, you have to select a transducer.
Example:
CORR:TRAN:DEL
Usage: Event
Manual operation: See "Delete Line" on page 574
[SENSe:]CORRection:TRANsducer:SCALing <ScalingType>
This command selects the frequency scaling of the transducer factor.
Configuring the R&S
FSW