Measurements
R&S
®
FSW
196User Manual 1173.9411.02 ─ 19
Fig. 5-30: Spectrum Emission Mask result displays
In addition to the graphical results of the SEM measurement displayed in the diagram,
a result summary is displayed to evaluate the limit check results (see also chap-
ter 5.6.4.2, "Limit Lines in SEM Measurements", on page 201).
The following information is provided in the result summary:
Label Description
General Information
Standard Loaded standard settings
Tx Power Power of the reference range
Tx Bandwidth Tx bandwidth used by the reference range
RBW RBW used by the reference range
Range results
Range Low Frequency range start the peak value was found in
Range Up Frequency range end the peak value was found in
RBW RBW of the range
Frequency Frequency of the peak power level
Power Abs Absolute peak power level within the range
Power Rel Peak power level within the range, relative to the "Tx Power"
ΔLimit
Deviation of the peak power level from the limit line
You can define in which detail the data is displayed in the result summary in the "List
Evaluation" settings (see chapter 5.6.5.7, "List Evaluation (Results Configuration)",
Spectrum Emission Mask (SEM) Measurement
To Next Page
Loading...
