Rohde & Schwarz FSW26 - Page 514

Common Analysis and Display Functions
R&S
®
FSW
514User Manual 1173.9411.02 ─ 19
7.4.3.6 Band Power Marker
For each of the 16 markers band power measurement can be activated. Band power
measurement markers are configured in the "Band Power Config" dialog box, using the
"Band Power" function.
The individual marker settings correspond to those defined in the "Marker" dialog box
(see "Individual Marker Setup" on page 493). Any settings to the marker state or type
changed in the "Marker Function" dialog box are also changed in the "Marker" dialog
box and vice versa.
To display the "Band Power Config" dialog box, do one of the following:
●
Press the MKR FUNC key, then select the "Select Marker Function" softkey. Then
select the "Band Power" button. Select the "Band Power Config" softkey.
●
In the "Overview", select "Analysis", and switch to the vertical "Marker Function
Config" tab. Then select the "Band Power" button. Select the "Band Power Config"
softkey.
For more information see chapter 7.4.1.10, "Measuring the Power in a Channel
(Band)", on page 491.
Band Power Measurement State................................................................................ 514
Span............................................................................................................................515
Power Mode................................................................................................................515
Switching All Band Power Measurements Off.............................................................515
Band Power Measurement State
Activates or deactivates band power measurement for the marker in the diagram.
Marker Usage