Remote Commands
R&S
®
FSW
686User Manual 1173.9411.02 ─ 19
INSTrument:MODE <OpMode>
The operating mode of the R&S FSW determines which applications are available and
active. Whenever you change the operating mode, the currently active measurement
channels are stored. The default operating mode is Signal and Spectrum Analyzer
mode, however, the presetting can be changed.
For details on operating modes and applications see chapter 4, "Applications and
Operating Modes", on page 96.
Parameters:
<OpMode> SANalyzer
Signal and Spectrum Analyzer mode
MSRanalyzer
Multi-Standard Radio Analysis (MSRA) mode
RTMStandard
Multi-Standard Realtime (MSRT) mode
Only available if the realtime option (R&S FSW-K160R) is instal-
led.
*RST: SAN
Example:
INST:MODE MSR
Switches to MSRA mode.
Usage: SCPI confirmed
INSTrument:REName <ChannelName1>, <ChannelName2>
This command renames a measurement channel.
Parameters:
<ChannelName1> String containing the name of the channel you want to rename.
<ChannelName2> String containing the new channel name.
Note that you can not assign an existing channel name to a new
channel; this will cause an error.
Example:
INST:REN 'Spectrum2','Spectrum3'
Renames the channel with the name 'Spectrum2' to 'Spectrum3'.
INSTrument[:SELect] <ChannelType> | <ChannelName>
This command activates a new measurement channel with the defined channel type,
or selects an existing measurement channel with the specified name.
Also see
● INSTrument:CREate[:NEW] on page 683
●
chapter 11.4.3, "Programming Example: Performing a Sequence of Measure-
ments", on page 690
Selecting the Operating Mode and Application
To Next Page
Loading...
